ICX

Ruckus / Brocade Switches

See Ruckus

Connect

Connect on Linux

# apt install tio
tio -b 9600 /dev/ttyS0
tio -b 9600 /dev/ttyUSB0

# apt install minicom
minicom -b 9600 -D /dev/ttyS0
minicom -b 9600 -D /dev/ttyUSB0

Connect on Windows

Use Tera Term or Putty and connect to COMX with Baud 9600

CLI

Show Config

show config
sh run

Configure

enable
configure terminal
# or conf t

Write Config

write mem

Clear Settings

erase startup-config

Reboot Switch

reload

Skip Pagination

>enable

to skip pagination:

skip
# or skip-page-display
  Disable page display mode

to page:

page
  Enable page display mode

Hostname

hostname [name]

dhcp

dhcp:

ip dhcp-client enable
ip dhcp-client auto-update enable
no ip dhcp-client enable

Static IP

ip address 10.10.10.104 255.255.255.0
ip default-gateway 10.10.10.1
no ip dhcp-client auto-update enable
no ip dhcp-client enable

Show Ethernet Interfaces

sh int bri

Show specific port:

show int eth 1/1/1

Show management port:

sh int bri | begin mgmt

Disable Interface

int eth 1/1/48
  disable
  enable

Show IP

show ip

Ping IP

ping [IP]

VLAN

Show VLANs:

show vlan

Clear VLAN:

no vlan [#]

License

Show licenses:

sh license

== Disable Spanning Tree:

On specific port:

interface ethernet 1/1/1
 loop-detection
 no spanning-tree
!

Users

enable super-user-password [PASSWORD]
no enable super-user-password

username admin [PASSWORD]
no username admin

Reset Password

As switch boots up, when you see the following, press 'b':

Enter 'b' to stop at boot monitor:

then type "no password":

no password

then type "boot" to continue booting:

boot
# or boot_primary

Then either change password

enable
conf t